Scheppach IGT3500 Translation Of Original Instruction Manual page 63

6. Check the spark plug gap. Set the electrode gap to 0.6 to 0.7 mm
with a feeler gauge.
7. The re-assembly takes place in reverse order.
NOTE
A loose spark plug can overheat and cause damage to the engine. Tight-
ening the spark plug too much can damage the thread in the cylinder
head.
10.2.5 Clean the fuel filter insert (Fig. 13 + 14)
Note: The fuel filter insert (25) is a filter cup which is located directly
under the tank cover (2) and filters all the fuel filled in.
1. Set the on/off switch (11) to the "OFF" position.
2. Open the tank cover (2).
3. Remove the fuel filter insert (25) and the fill level marking (26). Clean
it in a non-flammable solvent or a solvent with a high flash point.
4. Reinsert the fuel filter insert (25) with the fill level marking (26).
5. Close the tank cover (2).
Please provide the following information in the event of any en-
quiries:
• Machine data - type plate
• Engine data - type plate
Important note in the case of repairs:
For return delivery of the device for repair, please ensure for safety rea-
sons that it is free of oil and fuel when it is sent to the service centre.
10.3 Ordering spare parts
Please provide the following information when ordering replacement
parts:
• Device type
• Device article number
www.scheppach.com
GB | 63