Tektronix SignalScout RFM150 User Manual page 166

Appendix C: Interface Port
Connecting Two Instruments
Before communication can occur between two instruments, they
must be connected as follows:
= Configure the interfaces of the two instruments identically,
according to the following procedure. This is essential.
= Connect the supplied RS232-C cable between the source and
destination instruments.
CONFIG CHAN CLOCK unassigned
F4 F5
Press UTIL, then select RS232. The RS232 menu will be displayed.
Figure C—2 shows the RS232 menu, with the factory shipped condi-
tion indicated by outline cursors.
The function keys are assigned to the five editable fields. Press a
function key to select the corresponding field for edit, then turn the
knob to the left or right to change the setting.
Exit. After all fields have been edited as desired, press ESC to exit
the menu, one level at a time. The new settings will be saved.
C-2 REM 150 SignalScout