Microtek Spector-AF10 Start Here Manual page 7

Problems?
The LEDs on the button panel indicates the status of the scanner.
Orange On – Scanner is on.
Both On – Ready to scan.
Green Flashing – Warming up or scanning.
Both Off – Scanner is off.
If you encounter any problems, check the section below and follow the suggested solution
if your problem is listed. You may also want to go over installation steps 1 to 4 of this
guide to make sure that you have followed all procedures properly.
1. No light comes on when the scanner is turned on.
Make sure your scanner is connected to your computer and plugged into a power
source.
Make sure your scanner is detected by your computer.
2. Add/Remove Hardware Wizard appears on your screen.
Click the "Cancel" button and close the ScanWizard DI. Disconnect the USB cable
from the back of your computer, and refer to the installation instructions in this guide.
3. When trying to scan, an error message appears on your screen that reads, "Can't Find
Scanners".
Make sure your scanner is unlocked (see Step 3).
Make sure your scanner is connected to your computer and plugged in to a power
source (see Step 4).
Uninstall and reinstall the ScanWizard DI software.
4. After clicking scan, a blank screen appears.
Make sure your scanner is unlocked (see Step 3).
Uninstall and reinstall the ScanWizard DI software.
5. Having trouble scanning the documents.
Make sure you place the document to be scanned properly on the scanner glass
surface.
Uninstall and reinstall the ScanWizard DI.
LED indicators
(Left: Green/Right: Orange)
7