Omron ZFX-C10 - COMMUNICATION Command Reference Manual page 16

Executing Measurement < MEASURE command >
Executing a Single Measurement
This command executes a single measurement.
< Command format >
M E A S U R E C R
< Response format >
When processing ends successfully
Measurement value
C R
O K
When processing fails
E R C R
< Explanation of parameters >
Measurement value
Important
Measurement values are output only when an expression is set at [Setup] - [Support] - [Calculation] - [Data], and [RS-
232C/422] or [USB] is specified at [System] - [Output] - [Data output].
14
About Communication Commands
or
M C R
C R
The acquired measurement value is returned. The measurement value is output in the
format (ASCII/binary) specified in the output conditions.
Configuration of Measurement Value Data p.7
ZFX-C Serial Communication Command Reference