Position Correction - Omron ZFX - SHORT MANUAL V1.0 Manual

2-4 Position Correction

2-4 Position Correction
TEACH
process
Inspection
With Position
Correction
Important
22
This function is used when the position or orientation of measurement target
is no fixed. If you use this function, the amount of the shift from the reference
position iscalculated, and the position of the measurement region is corrected
before measurement is performed.
Image input
Image input
"Position Correction" recognizes
the amount of the position shift.
Use a saved image, when setting the position correction.
If you use an image different from the one that was initially used for position
correction, position correction might not be set correctly. Moreover, set the
measurement items again, if you use a different image.
Recommended procedural
Registering the live image
MENU mode - [Setup] - [Register] - [Image 0] - [Register image] - [Live image]
Position correction
0.Pattern Region
Register model
Reference model
Search region
Reference point
Inspect Img Adj
Region
Image sw
Saving the image into SD card
MENU mode - [Setup] - [Register] - [Image 0] - [Save to SD card]
--> In case that you need to adjust the position correction, you can use the same
image in SD card.
TEACH process
of Position Correction
Position Correction
SD
TEA
Detail Limits
Setup menu Capture
Main Operation
TEACH process
of measurement Item
Measuring the
area of grey part
Measurement
"Position Correction" fixes the
position of measurement region.
Push [Image SW]. After that, the
image which is used for position
correction is switched.