1-2 Connecting the Devices
1-2-3
Connecting the Camera to the Controller
Important
Important
Important
Disconnection procedure
Important
Important
1. Insert the camera's connector into the
Controller's Camera connector.
2. Tighten the two fastening screws of the
Controller's Camera connector.
Tightening torque: 0.15 Nm.
Do not touch the terminals inside the connector.
Fasten the connector while making sure that it is not subjected to vibration or
shock.
Do not mount the Controller in such a way that a load is steadily applied on
the connector, for example, with tension applied to the cables.
Loosen the fastening screws (two locations) to unlock the camera's cable, and
then pull the camera's cable connector straight out.
Be sure to hold the connector of the camera to disconnect it. Failure to do so
may damage the camera's cable.
Do not touch the terminals inside the connector.
Preparation
7