Omron ZFX - SHORT MANUAL V1.0 Manual page 10

1-3 Installing the Controller
Important
Removing procedure
1-3-3 Mounting on the Panel
Attach the Exhaust Unit (supplied) to the Controller when installing other
devices adjacently on the same DIN track as the Controller.
OMRON USB
OUTPUT RUN ERROR ENABLE
ZFX-C10
ADJ
MENU
AUTO
1 2 3 4
DIN track (sold separately)
PFP-100N (1 m)
PFP-50N (0.5 m)
PFP-100N2 (1 m)
1. Pull the Controller's lower hook downwards.
2. Lift up the Controller from its bottom to re-
move it from the DIN track.
1. Install the long Panel Mount
Adapters on the four holes on the
Controller.
2. Install the short Panel Mount
Adapters on the two holes on the
long Panel Mount Adapter.
3. Install the Controller with Mount
Adapters attached onto the panel
from the front.
4. Hook the hooks of the mounting
bracket onto the two holes (two
each at top and bottom) of the
longer Mount Adapters and tight-
en the screws.
Tightening torque: 1.2 N•m.
5. Make sure that the Controller is
firmly fixed on the panel.
End Plate (sold separately)
PFP-M
Exhaust Unit
SD
CARD
RUN
ESC
SET
PULL OPEN
Panel mount adapters
2
Preparation
1
2
Panel
1
3
2
1
4
Mounting bracket
9