Changing The Video Board Field Setting - Omron NS - MANUAL 2 Operation Manual

3-1 Display
No. Item
(1) Object Comment
(2) Select Input ch
3-1-3

Changing the Video Board Field Setting

Select the type of Video Input Unit that will be used in the project from the Video
Board Field in the System Dialog Box. The System Dialog Box can be displayed by
selecting PT – System Setting from the CX-Designer menus. (For details, refer to
3-4-1 System Settings.) It must be set when a project is first created because the
functions available with each Unit vary slightly. Changing this setting changes the
current project. If you change the setting while a project is being edited and then try
to save the project, you will get a dialog box telling you that the project has been
changed and asking you where to save it. Specify where to save the project.
Reference
3-12
Used to write descriptive comments about the video display
object (up to 32 characters long).
Selects analog RGB image display for the video display
object.
RGB: Analog RGB input
Only the NS-CA002 can be used with the NS15. If the project is set for
the NS15, you cannot change the Video Input Unit. If the NS-CA001 is
set in the project, you cannot change the PT model to the NS15.
Contents
(1)
(2)