Table of Contents
Advertisement
2-3 Installing the RGB and Video Input Unit
2-3 Installing the RGB and Video Input Unit
This section describes the procedure for installing the RGB and Video Input Unit on
the PT.
• Do not touch the surface of the circuit board or the components mounted to it with
Note
• After installing the Unit on the PT, always secure it with the screws provided. The
• Before installing or removing the Unit, make sure that the Unit and the PT are
•
When complying with the EC Directive for the NS hardware with an RGB and Video
Input Unit mounted, make sure that the NS hardware is mounted on the control
panel and each cable is connected with a ferrite core.
Recommended Control Panel
Model
EC-SCF16-45
Recommended Ferrite Cores
Model
ZCAT1518-0730
ZCAT1518-0730
ZCAT2035-0930
ZCAT1325-0530
ZCAT-3035-1330
ZCAT-2436-1330
Installing the RGB and Video Input Unit
(1) Install the RGB and video board so that its expansion interface connector is
inserted into the expansion interface connector on the back of the PT and the
respective screw holes are aligned. Hold the RGB and video board by the
corners, keeping it parallel to the back of the PT.
Position of screws
for attaching the
board to the PT.
2-4
your bare hands.
applicable mounting torque is 0.6 N·m.
turned OFF. Make sure that installing or removing is carried out correctly as
described in Installing or Removing.
When the Unit is installed, the depth of the PT increases by 24 mm. Make sure that
there is enough space in the control panel before installing the Unit.
Manufacturer
Nitto Electric Works, Ltd.
Manufacturer
TDK
TDK
TDK
TDK
TDK
TDK
Cable
Video Cable
Console Cable
RGB Monitor Cable
FG Cable
AC Power Cable
AC Power Cable
Screw holes for
attaching
expansion boards.
Align the positions of the holes.
Advertisement
Table of Contents
