Connecting The Rgb Input Connector - Omron NS - MANUAL 2 Operation Manual

2-5 Connecting the RGB Input Connector

2-5 Connecting the RGB Input Connector

This section describes the procedure for connecting an analog RGB output device,
such as a computer, to the RGB and Video Input Unit installed on a PT.
The cable's tensile load is 30 N maximum. Do not subject it to loads
Note
greater than this.
Connecting the RGB Input Connector
(1) Insert the socket of the RGB cable into the RGB input connector on the RGB
and Video Input Unit.
(2) Tighten the screws firmly to secure the connector.
Disconnecting the RGB Input Connector
(1) Loosen the screws of the connector.
(2) Carefully remove the RGB cable from the connector on the RGB and Video
Input Unit.
2-12
(1)
(2)
(2)
(1)