Connecting The Console Port Connector - Omron NS - MANUAL 2 Operation Manual

2-6 Connecting the Console Port Connector

This section describes the procedure for connecting the console port connector of
an OMRON Vision Sensor (F150-C10V3, F160-C10V2, F180-C10, F400-C10V2,
F250-C10, or V530-R150V2) to the RGB and Video Input Unit installed on a PT.
This connection requires an OMRON Relay Cable (F150-VKP).

Connecting the Console Port Connector

Insert the socket of the Relay Cable (F150-VKP) into the RGB and video board's
console port connector.
The socket locks into place when it is inserted.
Disconnecting the Console Port Connector
Remove the Relay Cable by pulling the collar back on the connector as shown
below.
2-6 Connecting the Console Port Connector
RGB and video board's
console port connector
Align with groove and insert.
Relay Cable (F150-VKP)
Console port connector
Pull here to unlock the cable and remove it.
Relay Cable (F150-VKP)
2-13