Event Inputs (Tc2) - Omron EJ1 User Manual

Other Functions (TC4 and TC2)
4-7-2

Event Inputs (TC2)

Event Input
Assignment
Note
Controlling Operation with
the Event Input's ON/OFF
Status
Note
There are two event inputs in the TC2.
The following diagram shows the parameters that can be set in event input 1
or event input 2.
Some of the parameters are for all channels and others are for individual
channels.
EV1
Settable
parameters
All channels
Disabled
Bank (bit 0)
Bank (bit 1)
Stop (0)/Run (1)
Run (0)/Stop (1)
Auto (0)/Manual (1)
Local SP (0)/Remote SP (1)
Variable type
F2/B2
Conditions for use
This parameter can be set only when operation is stopped.
When this parameter has been changed, the new setting becomes effective
the next time a software reset is performed for the Unit or the next time power
is turned ON.
• Operation can be switched by OFF-to-ON or ON-to-OFF event-input tran-
sitions.
ON
OFF
■ Stop (0)/Run (1), Run (0)/Stop (1), Auto (0)/Manual (1), Local SP (0)/
Remote SP (1)
Stop (0)/Run (1)
Run (0)/Stop (1)
Auto (0)/Manual (1)
Local SP (0)/Remote SP (1) (See note.)
This function can be used only when the Remote SP Enable parameter is set
to 1 (Enable).
EV2
EV2 can be set in the same way.
Channel 1
Bank (bit 0)
Bank (bit 1)
Stop (0)/Run (1)
Run (0)/Stop (1)
Auto (0)/Manual (1)
Local SP (0)/Remote SP (1)
Parameter name
Event Input 1 or 2 Assignment
(Common)
No special conditions
Parameter
Section 4-7
Channel 2
Bank (bit 0)
Bank (bit 1)
Stop (0)/Run (1)
Run (0)/Stop (1)
Auto (0)/Manual (1)
Local SP (0)/Remote SP (1)
Setting range Default
0 to 69 0
Event input Description
OFF Stop
ON Run
OFF Run
ON Stop
OFF Auto
ON Manual
OFF Local SP
ON Remote SP
105