Omron EJ1 User Manual page 277

Parameter List
Vari- CompoWay/F Modbus
able
Category Add- Address
type
ress
F0 Enabled 0040 A240 Output ON Scheduling Method
(B0) after
resetting.
Not used.
0042 A242 Delay Between Output Channels (See note 2.) H' 00000000 to H' 000003E8 (0 to 1000)
Note (1) Not valid when an NT Link is being used.
(2) Set the Delay between Outputs parameter to an even number. If an odd number is set, the next
smaller even number will be used.
(3) Parameters with the following mark are supported only by version 1.1 Temperature Controllers:
V1.1
Refer to Functional Upgrades on page xxvi for details on upgraded functionality.
(4) ... Can only be used by improved models.
V1.2
For details on improved models, refer to Functional Upgrades on page xxiv.
252
Parameter name
H' 00000000: No control (0)
H' 00000001: 1/2 (1)
H' 00000002: 1/4 (2)
Setting (monitor) range
Appendix
De- Unit Attrib- Target Unit
fault utes
TC4/ HFU
TC2
Common ●
0 --- ---
TC4 ---
Common ●
10 ms ---