Omron EJ1 User Manual page 61

Minimum Configuration for Control
EJ1N-TC2A-QNHB 0
CH1
Control in progress parameters
Bank 0
Adjustment settings
HB/HS/OC settings 1
Control stopped parameters
Input settings
Output settings
Alarm settings
Operation commands
RUN - CH1
STOP - CH1
Manual - CH1
Auto - CH1
100% AT Execute - CH1
AT Cancel - CH1
36
4. The following table shows the related parameter settings for this example.
CX-Thermo Basic Mode Setting Example
Bank 0 Set Point - CH1
Bank 0 Proportional Band - CH1
Bank 0 Integral Time - CH1
Bank 0 Derivative Time - CH1
Bank 0 Alarm Value 1 - CH1
Bank 0 Alarm Upper Limit Value 1 - CH1 0 C
Bank 0 Alarm Lower Limit Value 1 - CH1 0 C
Bank 0 Alarm Value 2 - CH1
Bank 0 Alarm Upper Limit Value 2 - CH1 0 C
Bank 0 Alarm Lower Limit Value 2 - CH1 0 C
Manual MV - CH1
Heater Burnout 1 Detection
Heater Burnout 2 Detection
Input Type - CH1
Temperature Unit - CH1
Control Period 1
Alarm 1 Type - CH1
Alarm 2 Type - CH1
Setting example
--- ---
150 C
8.0 C Default
233 s Default
40.0 s Default
0 C
Upper limit alarm; not used.
Upper limit alarm; not used.
0 C
Upper limit alarm; not used.
Upper limit alarm; not used.
0.0% Disabled in Auto mode
--- ---
0.0 A HB alarm OFF
0.0 A HB alarm OFF
--- ---
5: Thermocouple (K)
C
--- ---
2 OUT1 control period: 2 s
--- ---
2: Upper-limit alarm
2: Upper-limit alarm
--- ---
Section 3-1
Remarks