Omron EJ1 User Manual page 39

Installation
Mounting to DIN Rail
Installation Method
3. Press in on the Units.
Removal Method
14
• Mount the EJ1 to DIN Rail.
• Use screws to secure the DIN Rail in at least 3 locations.
DIN Rail: PFP-50N (50 cm) or PFP-100N (100 cm)
• Install the DIN Rail vertically to the ground.
Vertical: OK
Pull down the hooks on the bottoms of the Units, and then catch the hooks on
the tops of the Units onto the DIN Rail and press the Units onto the DIN Rail
until they lock into place.
2. Catch the upper hooks onto the DIN Rail.
1. Pull down the hooks.
Pull down on the hooks with a flat-blade screwdriver and lift up on the Units.
Flat-blade screwdriver
Horizontal: NG
4. Make sure the Units are
locked into place.
Flat-blade screwdriver
(unit: mm)
Section 2-1