Cancel Latch; Sp Mode - Omron E5AR - MANUAL 2 User Manual

Section 7 Communication (Modbus)

■ Cancel latch

Command
Response

■ SP mode

Command
7-28
Slave Function Write start Instruction
address mode address code
H'06 H'00 H'00 H'0C
1 1 2 2
Related
information
Ch
H'00 1
H'10 2
H'20 3
H'30 4
H'F0 All
This command cancels alarm latch. The command is used when the
alarm latch function is in use.
This command can be used in both setting area 0 and setting area 1.
If AT is being run in the specified channel, an operation error will
result.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
Slave Function Write start Instruction
address mode address code
H'06 H'00 H'00 H'0C
1 1 2 2
The above indicates a normal end. For information on error responses,
see "7.7 Operation commands (Communication/Modbus)" (P.7-14).
Slave Function Write start Instruction
address mode address code information
H'06 H'00 H'00 H'0D
1 1 2 2
Related
information
Ch
H'00
1
H'01
H'10
2
H'11
H'F0
All
H'F1
Use this command to select the SP mode (Local SP / Remote SP).
The command can be used when cascade control or remote SP is in
use.
This command can be used in both setting area 0 and setting area 1.
If AT is being run in the specified channel, an operation error will
result.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
Related
information CRC-16
2 bytes
Description
Command
Cancel alarm latch
Cancel alarm latch
Cancel alarm latch
Cancel alarm latch
Cancel alarm latch
Related
information CRC-16
2 bytes
Related
CRC-16
2 bytes
Description
Command
Local SP
Remote SP
Local SP (Cascade open)
Remote SP (Cascade closed)
Local SP
Remote SP