Omron E5AR - MANUAL 2 User Manual page 239

Section 8 Setting data
Input 1 input type
Input 2 input type
Input 3 input type
Input 4 input type
Function
Setting
Reference
Reference
8-36
i1-t
i2-t
i3-t
i4-t
• These settings are used to set the sensor type.
• If these settings are changed, the SP limit settings are returned to
the initial settings. In this case, reset the "SP upper limit" and "SP
lower limit" settings as necessary.
• Refer to the following table to configure the settings. Initial settings
are shaded.
Setting Input
value type
0 Pt100(1) -200.0 to 850.0
1 Pt100(2) -150.00 to 150.00 -199.99 to 300.00
2 K(1) -200.0 to 1300.0
3 K(2) -20.0 to 500.0
4 J(1) -100.0 to 850.0
5 J(2) -20.0 to 400.0
6 T -200.0 to 400.0
7 E 0.0 to 600.0
8 L -100.0 to 850.0
9 U -200.0 to 400.0
10 N -200.0 to 1300.0
11 R 0.0 to 1700.0
12 S 0.0 to 1700.0
13 B 100.0 to 1800.0
14 W 0.0 to 2300.0
15 Depends on scaling
4 to 20 mA
One of the following ranges appears
16
0 to 20 mA
depending on the scaling:
17 1 to 5V
18 0 to 5V
19 0 to 10V
Set the input type switch of each input to match the "Input type" setting
of the corresponding input.
The initial setting is "2". ("TC.PT")
● Related setting data
"Input temperature units" (Input initial setting level) (P.8-37)
"SP upper limit", "SP lower limit" (Control initial setting level) (P.8-43)
Setting range
(°C) (°F)
-300.0 to 1500.0
-300.0 to 2300.0
0.0 to 900.0
-100.0 to 1500.0
0.0 to 750.0
-300.0 to 700.0
0.0 to 1100.0
-100.0 to 1500.0
-300.0 to 700.0
-300.0 to 2300.0
0.0 to 3000.0
0.0 to 3000.0
300.0 to 3200.0
0.0 to 4100.0
-19999 to 99999
-1999.9 to 9999.9
-199.99 to 999.99
-19.999 to 99.999
-1.9999 to 9.9999
l.0
Input type
switch
TC.PT
TC.PT
IN1
TYPE
ANALOG
ANALOG
TC.PT
IN1
TYPE
ANALOG