Forced Set/Reset Cancel - Omron SYSMAC CV Series Operation Manual

FORCED SET/RESET CANCEL

Response Format
Parameters
Data area
OP1 OP2 OP3
C I O
L R (S)
H R (S)
T I M
C N T
5-27 FORCED SET/RESET CANCEL
Command Format
Response Format
@
1 0
x 10 x 10
Unit no.
Data area, word, bit (command format): Specify in four characters the CIO,
Timer, or Counter Area to be force-reset. Specify in BCD the word (four digits)
and the bit to be force-reset (2 digits).
Name
OP4
(S) CIO Area 0000 to 2555 (all CV-series PCs)
(S) Link Area 0000 to 0063 (see note 1) (all CV-series PCs)
(S) Holding Area 0000 to 0099 (see note 2) (all CV-series PCs)
(S) Timer Area 0000 to 0511 (CV500 or CVM1-CPU01-E)
(see note 3) 0000 to 1023 (CV1000, CV2000, or
CVM1-CPU11-E)
(S) Counter Area 0000 to 0511 (CV500 or CVM1-CPU01-E)
(see note 4) 0000 to 1023 (CV1000, CV2000, or
CVM1-CPU11-E)
(S): Space
Note 1. These correspond to CIO words 1000 to 1063. They do not actually have to
be set as link bits.
2. These correspond to CIO words 1200 to 1299. They do not actually have to
be set as holding bits.
3. The relevant instructions are TIM, TIMH, TTIM, TIMW, and TMHW.
4. The relevant instructions are CNT, CNTR, and CNTW.
5. The space (S) is added because four characters are needed to specify a
data area.
Cancels all forced-set and forced-reset bits.
@
1 0
x 10 x 10
Unit no.
@
1 0
x 10 x 10
Unit no.
K R
1 0
x 16 x 16
Header Response FCS
code code
Word designation
*
K C
Header FCS Terminator
code
K C
1 0
x 16 x 16
Header Response FCS
code code
Section 5-27
* s
Terminator
Bit
designation
00 to 15 (in BCD)
00 (fixed)
s
* s
Terminator
93