Table of Contents
Advertisement
2.2.3 Connect Power
When all other connections have been made, you can connect power to the Prototyping Board.
Connect the wall transformer to jack J8 on the Prototyping Board as shown in Figure 3.
Plug in the wall transformer. The power LED on the Prototyping Board should light up. The
RCM3400 and the Prototyping Board are now ready to be used.
NOTE: A RESET button is provided on the Prototyping Board to allow a hardware reset
without disconnecting power.
2.2.3.1 Overseas Development Kits
Development kits sold outside North America include a header connector that may be con-
nected to 3-pin header J9 on the Prototyping Board. The connector may be attached either way
as long as it is not offset to one side. The red and black wires from the connector can then be
connected to the positive and negative connections on your power supply. The power supply
should deliver 8 V–24 V DC at 8 W.
10
RabbitCore RCM3400
Advertisement
Table of Contents
Need help?
Do you have a question about the RabbitCore RCM3400 and is the answer not in the manual?
Questions and answers