Rabbit RabbitCore RCM3400 User Manual page 100

The following options require more care in address selection and testing actions, as
conflicts with other users, servers and systems can occur:
LAN — Connect the RCM3400 Prototyping Board's Ethernet port to an existing LAN,
•
preferably one to which the development PC is already connected. You will need to
obtain IP addressing information from your network administrator.
The RCM3400 is capable of direct connection to the Internet and other Wide
WAN —
•
Area Networks through the Prototyping Board, but exceptional care should be used
with IP address settings and all network-related programming and development. We
recommend that development and debugging be done on a local network before con-
necting a RabbitCore system to the Internet.
TIP: Checking and debugging the initial setup on a micro-LAN is recommended before
connecting the system to a LAN or WAN.
The PC running Dynamic C through the serial port on the RCM3400 Prototyping Board
does not need to be the PC with the Ethernet card.
3. Apply Power
Plug in the AC adapter. The RCM3400 module and Prototyping Board are now ready to
be used.
94 RabbitCore RCM3400