Actuator Setup For Utilization; Transport, (Temporary) Storage And Downtimes; Packaging; Safe Disposal Of Packaging - ARIS ExTensor Original Declaration Of Incorporation With Manual

3.4.1 Weights
ExTensor "S"
ExTensor "M"
ExTensor "L"
ExTensor "XL"
4.

Actuator setup for utilization

4.1

Transport, (temporary) storage and downtimes

Use the factory packaging for transport to the installation point.
Replace a damaged original packaging by a new solid packaging.
• Actuator with attached valve: only attach lifting gear to the valve and NOT to the actuator
• ARIS actuators must not be used as a climbing or supporting aid
• ARIS actuators must not be operated in unsecured lifting mode without additional applications
• Storage in well-ventilated and dry rooms
• Protection against possible soil moisture (shelf storage)
• For longer storage times, moisture-absorbing agents should be placed in the drive
• The drives must be protected from dust and dirt
• Actions must be taken to avoid the formation of condensation (e.g. in the event of temperature uctuations)
4.2

Packaging

ARIS drives are protected by special cardboard packaging for transport from the factory. Unpacking in the Ex area is not permitted
as the materials could become electrostatically charged.
4.3

Safe disposal of packaging

Additionally necessary packaging is made by easily separable packaging materials and can be recycled individually:
• Wood
• Cardboard
• Paper
• Plastics
4.4

Installation and mounting

Installation, electrical connection, commissioning, operation and maintenance may only be carried out by trained specialist person-
nel who have been authorized by the system operator or system manufacturer.
Personnel requirements: National requirements, EN IEC 60079-14, EN IEC 60079-17, EN IEC 60079-19.
Before commissioning or working on this actuator, the personnel must have read and understood these instructions and also know
and observe the applicable rules for occupational safety. Work in hazardous areas is subject to special conditions that must be
observed. The plant manufacturer/operator is responsible for compliance and monitoring.
12
6.5 kg
7.5 kg
8.5 kg
15.5 kg
Weights are approximate and may vary
slightly depending on the equipment variant.
ExTensor