Programming Console Operations; Overview - Omron CQM1H - 08-2005 Operation Manual

Programming Console Operations

7-3

Programming Console Operations

7-3-1

Overview

Name
Clearing memory
Reading/clearing error
messages
Buzzer operation
Reading and assigning
expansion instruction
function codes
Setting a program memory
address
Reading a program
memory address and
monitoring bit status
Entering or editing
programs
Instruction search
Bit operand search
Inserting and deleting
instructions
Checking the program
Bit, digit, word monitor
Multiple address monitor
Binary monitor
Three-word monitor
If the Programming Console is connected to the PC when PC power is
already ON, the first display below will indicate the mode the PC was in before
the Programming Console was connected. Ensure that the PC is in PRO-
GRAM mode before you enter the password. When the password is
entered, the PC will shift to the mode set on the mode switch, causing PC
operation to begin if the mode is set to RUN or MONITOR. The mode can be
changed to RUN or MONITOR with the mode switch after entering the pass-
word.
CLR
MONTR
Indicates the mode set by the mode selector switch.
The following table lists the programming and monitoring operations that can
be performed from a Programming Console. Refer to the rest of this section
for details on operational procedures.
Clears all or part of the Program Memory and any data areas that are not
read-only, as well as the contents of the Programming Console's memory.
Displays and clears error messages and displays MESSAGE instruction
messages.
Turns ON and OFF the buzzer that sounds when Programming Console
keys are pressed.
Reads or changes the function codes assigned to expansion instructions.
(Pin 4 on the DIP switch must be ON to assign function codes to expansion
instructions.)
Sets the specified program memory address when reading, writing,
inserting and deleting programs.
Reads the contents of the Program Memory. Displays the status of the
currently displayed bit in PROGRAM and MONITOR modes.
Overwrites the contents of the current Program Memory to either input a
program for the first time or to change a program that already exists.
Finds occurrences of the specified instruction in the program.
Finds occurrences of the specified operand bit in the program.
Inserts or deletes instructions from the program.
Checks for programming errors and displays the program address and error
when errors are found.
Monitors the status of up to 16 bits and words, although only 3 can be
shown on the display at one time.
Monitors the status of up to 6 bits and words simultaneously.
Monitors the ON/OFF status of any word's 16 bits.
Monitors the status of three consecutive words.
<PROGRAM>
PASSWORD!
<PROGRAM>
Function
Section 7-3
BZ
Page
154
156
157
157
158
158
159
162
163
164
165
166
167
168
168
153