Omron CJ1W-EIP21 - 10-2010 Operation Manual page 185

Setting Tag Data Links
Note
The following dialog box will be displayed before the Wizard starts.
Click the Yes Button to delete the connections that have been set with OM-
RON PLCs before starting the Wizard.
3. Create the connection following the instructions that are given by the Wiz-
ard after the Wizard starts. (See the following figure.)
4. A list of tag sets is displayed on the right side of the Wizard Dialog Box with
target devices that support receiving input data.
Select the tag sets that you want to receive at the originator device.
The following tables describes the meanings of the icons and check marks
displayed in the tag set list.
Icon Display position
All
Device
Tag set
All
Device
All
Device
Tag set
Device
Tag sets that are used in connections that are already set are not displayed.
Status
All output tag sets for all devices are selected.
All output tag sets for the applicable device are
selected.
The applicable output tag sets are selected. These
are the tag sets that will be set in the connection.
All or some output tag sets for some devices are
selected.
Some output tag sets for applicable devices are
selected.
All output tag sets for all devices are not selected.
All output tag sets for applicable devices are not
selected.
The applicable output tag sets are not selected.
The connections for this tag set will be deleted.
No applicable tag sets.
Section 6-2
157