Environmental Recycling Policy - Clarke CONTRACTOR CON1500WC Operation & Maintenance Instructions Manual

5. When wheel is binding or when interrupting a cut for any reason, switch off
the power tool and hold the power tool motionless until the wheel comes
to a complete stop. NEVER attempt to remove the cut-off wheel from the
cut while the wheel is in motion, otherwise kickback may occur. Investigate
and take corrective action to eliminate the cause of wheel binding.
6. DO NOT restart the cutting operation in the workpiece. Let the wheel reach
full speed and carefully re-enter the cut. The wheel may bind, walk up or
kickback if the power tool is restarted in the workpiece.
7. Use extra caution when making a "pocket cut" into existing walls or other
blind areas. The protruding wheel may cut gas or water pipes, electrical
wiring or objects that can cause kickback.
SAFETY SYMBOLS FOUND ON THE PRODUCT
The meanings of the markings and symbols on the product are shown below

ENVIRONMENTAL RECYCLING POLICY

By purchasing this product, the customer is taking on the obligation
to deal with its safe disposal in accordance with the Waste Electrical
and Electronic Equipment (WEEE).
This means that this product must not be disposed of with general
household waste. It must be disposed of according to the laws governing
Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal
facility.
If disposing of this product or any damaged components, do not dispose of
with general waste. This product contains valuable raw materials. Metal
products should be taken to your local civic amenity site for recycling of metal
products.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Read this manual
before use and keep
in a safe place for
future reference
Gloves should be
worn when cutting.
Wear eye protection
when using this tool.
Wear dust mask.
6