Care And Maintenance; After Use; Changing The Carbon Brushes - Clarke CONTRACTOR CON1500WC Operation & Maintenance Instructions Manual

CARE AND MAINTENANCE

AFTER USE

1. Clean away any accumulated dust.
2. Check the condition of the cutting disc for signs of cracking, and discard
immediately if apparent.
3. Keep the cooling vents clear.
4. Clean the housing with a soft cloth. Any worn or damaged parts should be
replaced by qualified personnel.
5. The bearings in the machine are sealed for life and require no
maintenance.
6. Refer to qualified service personnel if internal maintenance is required.

CHANGING THE CARBON BRUSHES

1. Use a screwdriver to remove the
carbon brush covers from the
machine body (one on each
side).
2. Remove worn brushes and insert
new ones as a matching pair.
3. Replace the brush holder covers.
STORAGE
1. Store the machine in a clean, dry
place, out of reach of children when not in use.
2. Always store in the case supplied.
GUARANTEE
This product is guaranteed against faulty manufacture for a period of 12
months from the date of purchase. Please keep your receipt which will be
required as proof of purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for the purpose for which it was
intended. Faulty goods should be returned to their place of purchase, no
product can be returned to us without prior permission. This guarantee does
not effect your statutory rights.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
12