Distech Controls ECx-Blind Series Instruction Manual page 12

To remove the terminal block cover, use a flat screwdriver as shown below to unclip the terminal cover from the strain relief.
Figure 23: Unclipping the terminal block cover
Disposal
The Waste Electrical and Electronic Equipment (WEEE) Directive set out regulations for the recycling and disposal of products. The WEEE2002/96/EG
Directive applies to standalone products, for example, products that can function entirely on their own and are not a part of another system or piece of
equipment.
For this reason Distech Controls products are exempt from the WEEE Directive. Nevertheless, Distech Controls products are marked with the WEEE
symbol , indicating devices are not to be thrown away in municipal waste.
Products must be disposed of at the end of their useful life according to local regulations and the WEEE Directive.
FCC Statement
Changes or modifications not expressly approved by Distech Controls could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
£ Reorient or relocate the receiving antenna.
£
Increase the separation between the equipment and receiver.
£
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
£ Consult the dealer or an experienced radio/TV technician for help.
Complementary Information
£
This product is not repairable. If the device is physically malfunctioning or requires repair, it must be returned to Distech Controls.
£ All traveling cables permanently installed present an X type anchor.
£ All cables must be able to operate above 176°F (80°C)
£
This device is designed for type 1 action.
£
This device is designed for type 1.b action.
£
The Ball Pressure Test temperature is 167°F (75°C).
£ This device presents an A class software.
£
The SELV does not exceed 42 VDC.
£
The maximum accessible voltage is 16 VDC.
Please note that manufacturer specific parameters implemented into the SMI motors are not supported. For configuration of the motors
please refer to SMI motor documentation and software.
12 / 21