Bracket Mounting; Auxiliary Alarm Option - Raytheon ST60 Owner's Handbook Manual

20

Bracket Mounting

A Control Unit Mounting Bracket (Part No. E25009) enables you to
mount your ST60 instrument in locations where other forms of
mounting are impractical. Although this provides a useful alternative
method for securing your instrument, it is only suitable for use in
positions where the instrument will not be exposed to water.
To bracket mount your ST60 instrument, do so in accordance with the
Control Unit Mounting Bracket Instruction Sheet.

Auxiliary Alarm option

The Auxiliary Alarm is waterproof and can be mounted on a panel
either above or below deck, as follows:
1. Drill a 22 mm (7/8in) diameter hole through the mounting panel
2. Place the foam seal in position on the back of the Auxiliary Alarm.
3. Feed the two-way connector block and connecting wires through
85mm (3.35in)
Auxiliary Alarm
as shown.
the drilled hole.
Foam gasket
Auxiliary
Alarm
Auxiliary Alarm wiring
ST60 Multi Instrument Owner's Handbook
45mm (1.8in)
Connector block
55 mm
(2.15 in)
D4411_1
D4412-1