Chapter 1: Operation
Chapter 1: Operation
1.1 Introduction
This handbook describes how to operate, maintain and install the
Raytheon ST60 Multi instrument.
Calibration requirement
The ST60 Multi instrument is calibrated to factory (default) settings
when first installed and must therefore be calibrated before use, in
accordance with the procedures in Chapter 4, Calibration, to ensure
optimum performance on your vessel.
Do NOT use the instrument until the calibration procedures have
been satisfactorily completed.
1.2 Normal operation
The information displayed on the ST60 Multi instrument is organised
in groups or 'chapters', and within each chapter, the different types of
information are presented as pages. The availability of pages on your
ST60 Multi instrument depends on:
• What information is available from SeaTalk. This handbook
• Which pages are enabled during Instrument configuration (see
Finding the information you want
The disposition of the ST60 Multi chapters and pages, is shown in the
following Chapter selection and content illustration. This illustration
assumes a system where all information sources are available.
assumes all data sources are available.
Chapter 4, Calibration). This handbook assumes all pages are
enabled.
1