Hold Mode - Panasonic HL-G2 Series User Manual

4.3 Sensing Setting

4.3.4 Hold Mode

■
Overview
Set a method to hold the measured value according to the measuring method of sensing
objects.
■
Setting method
The following describes a method to hold the measured value using an external trigger input.
When "None (Normal mode)" is selected, the measured value can be held by selecting either
one of the following two types: "Hold" or "One Shot".
When selecting an item other than "Normal mode", the measured value can be held only by
selecting "Hold". For detailed setting procedure, refer to
● If "One Shot" was selected in "Trigger Mode" and when the hold mode is set to an item other
than "None (Normal mode)", selection is automatically changed to "Hold."
Setting item

Hold mode

■
Timing chart
The diagram shown in the following explanation shows an example where"Hold"is set in the
trigger mode.
4-16
Set value
None (Normal mode)
Peak Hold
Bottom Hold
Peak to Peak Hold
"4.6.3 Trigger Mode".
Default value
None (Normal mode)
WUME-HLG2AN-2