Error Messages And Action Methods - Panasonic HL-G2 Series User Manual

6.2 Error Messages and Action Methods

6.2 Error Messages and Action Methods
If an error occurs during setting or measurement, one of the error codes listed below will be
displayed on the display section.
Error code
Dark level adjustment error
E100**
E120** CPU error
E130** Internal memory access error (system area)
Internal memory access error (user area)
E131**
E140** Internal access error
E150** Start processing error
E200** Beam-emitting circuit error
E211**
E212** Overcurrent detection error
E213**
(Note 1) Internal information is set in the last two digits ("**" section) of each error code.
● When an error has occurred, check whether the sensor is subject to excessive vibration.
● If the product still does not operate normally after you cleared the above, contact our
office.
6-4
Description Action method
Install the sensor so that strong light or
fluctuating light does not enter the sensor, and
turn the power OFF and then ON.
Turn the power OFF and then ON.
Turn the power OFF and then ON.
Refer to "4.8.5 Settings Initialization"
execute Set value initialization.
Turn the power OFF and then ON.
Turn the power OFF and then ON.
We recommend that the sensor be replaced.
Turn OFF the power and check the load.
and
WUME-HLG2AN-2