Maintenance - Husqvarna LF 60i LAT Operator's Manual

1. Loosen the handle knobs (A).
B
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
WARNING:
before you do maintenance on the product.
General product maintenance
Do a general inspection.
Clean the product.
Clean the battery and the battery charger.
Make sure that the "STOP" button operates correctly and is not damaged.
Examine the battery for damage.
Examine the battery charger for damage and make sure that it operates correctly.
Examine the connections between the battery and the product. Also examine the
connection between the battery and the battery charger.
Examine the vibration damping units for damage.
Examine the tension of the belt and look for damages. Adjust or replace the belt if it is
necessary.
To clean the product
1. Remove the batteries from the product. Refer to
install and remove the batteries on page 17 .
2. Make sure that the battery covers are closed.
1948 - 003 - 13.02.2024
A

Maintenance

Read and understand the
Remove the batteries
2. Lower the handle (B).
3. Tighten the handle knobs (A).
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
3. Clean the product with compressed air or running
water from a hose.
To
Before use Each 100 h
X
X
X
X
*
*
*
X
X
15