Operation - Husqvarna LF 60i LAT Operator's Manual

To do before you operate the product
• Read the operator's manual for this product carefully
and make sure that you understand the instructions.
• Read the operator's manual for the battery and the
battery charger carefully and make sure that you
understand the instructions.
• Do daily maintenance. Refer to
schedule on page 15 .
• Make sure that only approved persons are in the
work area, because there is a risk of serious injury.
• Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
Battery status
The battery status indicator (A) comes on when you start
the product. If you use 2 batteries, the battery status
indicator shows the total charge level for the 2 batteries
in the product.
A
State of charge
The battery charge level is 76%–
100%.
The battery charge level is 51%–
75%.
The battery charge level is 26%–
50%.
The battery charge level is 6%–
25%.
12

Operation

Maintenance
Symbol in the
status indicator
State of charge
The battery charge level is 0%–5%.
To fill the water tank
You can fill the water tank when it is installed on the
product, or remove and fill the water tank. To remove
and fill the water tank, do the steps that follow:
1. Lift the front part of the rubber lock (A) and lift the
water tank from the product.
A
2. Fill the water tank with water.
CAUTION:
than water to the water tank. Other fluids
can cause damage to the product and be
harmful to the environment.
3. Lift the front part of the rubber lock and push down
the water tank into the tank holder.
Symbol in the
status indicator
Do not add other fluids
1948 - 003 - 13.02.2024