Download
Share
Print this page
Husqvarna LG 300 Operator's Manual
  1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Power Tool
  5. LG 300
  6. Operator's manual

Husqvarna LG 300 Operator's Manual

Hide thumbs

Advertisement

Quick Links

LG 300
EN
Operator's manual
2-26

Advertisement

loading

Related Manuals for Husqvarna LG 300

Summary of Contents for Husqvarna LG 300

  • Page 1 LG 300 Operator's manual 2-26...

  • Page 2: Table Of Contents

    Contents Introduction..............2 Transportation, storage and disposal......21 Safety................6 Technical data.............. 23 Operation..............11 EC Declaration of Conformity........26 Maintenance..............14 Introduction California Proposition 65 WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
  • Page 3 Product overview (LG 300, Honda) 1. Operator's manual 11. Type plate 2. Handle 12. Vibration damping units 3. Throttle control Note: There are also 6 vibration damping units 4. Safety frame between the handle and the engine plate. Refer to 5.
  • Page 4 Product overview (LG 300, Hatz) 1. Operator's manual LED indicator overview (LG 300, Hatz) 2. Handle 3. Throttle control 4. Safety frame 5. Lifting point 6. Lock lever for the handle 7. Ignition key 8. Hydraulic oil dipstick 9. Hydraulic oil tank 10.
  • Page 5 • D: Engine temperature. This LED comes on if the • E: Air filter. This LED comes on if there is blockage engine temperature is too high. Not used. in the air filter. Not used. Engine overview Honda Hatz 1. Muffler 2.

  • Page 6: Safety

    Move the product rear- ward. Hydraulic oil level. The vibrations start. Symbol for a position of the throttle control. Note: Other symbols/decals on the product refer to special certification requirements for some markets. Risk of injury. Be careful around the drive belt.
  • Page 7 General safety instructions • Make sure that only approved persons are in the work area. • Keep the work area clean and bright. • Make sure that you are in a safe and stable position WARNING: Read the warning instructions during operation.
  • Page 8 loss of strength, changes in skin color or • The exhaust fumes from the engine contain carbon condition. monoxide which is an odourless, poisonous and very dangerous gas. To breathe carbon monoxide can • Symptoms can increase in cold temperatures. Use cause death.
  • Page 9 • Do a check of the safety devices regularly. If the safety devices are defective, speak to your Husqvarna service agent. Engine ON/OFF switch The engine can only start when the engine ON/OFF switch is set to "ON". The engine stops when you set the engine ON/OFF switch to "OFF".
  • Page 10 WARNING: Read the warning instructions has a deformation or is damaged, speak to that follow before you use the product. an approved Husqvarna service agent. • If the maintenance is not done correctly and regularly, the risk of injury and damage to the product increases.

  • Page 11: Operation

    Operation Introduction To start the product (LG 300, Honda) 1. Open the fuel valve. WARNING: Read and understand the safety chapter before you use the product. To do before you operate the product •...
  • Page 12 3. Set the engine ON/OFF switch to OFF. The engine stops. 4. Move the fuel valve to the OFF position. To start the product manually (LG 300, Hatz) 1. Set the throttle control to idle speed. 6. Release the starter rope handle to let the starter rope go back.
  • Page 13 4. Let the engine operate at idle speed for 2–3 minutes. 5. Set the throttle control to full throttle. To start the product, electrical start (LG 300, Hatz) 1. Set the throttle control to idle speed.

  • Page 14: Maintenance

    • To operate the product forward, move the operation • To operate the product rearward, move the operation control fully forward and release it. control fully rearward and release it. • To stop the movement of the product, move the operation control in the opposite direction in small movements until the product is stationary.
  • Page 15 General product maintenance Before use, Weekly, Monthly, Yearly, each each 10 h each 100 h each 250 h 500 h Replace the hydraulic oil. Engine maintenance, Honda Before use, After the Weekly, Yearly, each each 10 h first 20 h each 100 h 300 h Do a check of the fuel level and the engine oil level.
  • Page 16 23 or the engine manual for the correct type of oil. • Remove grease and oil from the handle. To replace the engine oil (LG 300, To do a general inspection Honda) • Make sure that all nuts and screws on the product are tightened correctly.
  • Page 17 To clean or or replace the air filter. Refer to replace the air filter (LG 300, Hatz) on page 18 . 7. Do a check of the engine oil level. To replace the engine oil (LG 300, WARNING: Stop the engine before Hatz) you do the maintenance.
  • Page 18 10. Push a clean cloth against the foam filter element to remove unwanted oil. 11. Install the air filter in the opposite sequence. To clean or replace the air filter (LG 300, Hatz) WARNING: Do not clean the air filter with compressed air. This causes damage to the air filter and the risk increases that you breathe the dangerous dust.
  • Page 19 3. Examine the V-belt for damages and wear. Replace 2. Tilt the product to drain the oil. the V-belt if it is necessary. 4. Do a check of the V-belt tension. 5. If the V-belt tension is not sufficient, do this procedure: Note: You can also use a manual oil drain pump to a) Loosen the screw on the belt tensioner (A).
  • Page 20 Let the product become cool trickle charging when the battery is fully charged. before you replace the hydraulic oil. Speak to your Husqvarna dealer for information about the correct battery charger. 1. Remove the dipstick (A) from the hydraulic oil tank.

  • Page 21: Transportation, Storage And Disposal

    5. Fill with hydraulic oil of the correct type. Refer to 6. Put the dipstick into the hydraulic oil tank. Technical data on page 23 . Transportation, storage and disposal Transportation 2. Attach the lifting equipment to the lifting eye. WARNING: Be careful during transportation.
  • Page 22 Obey the local recycling requirements and applicable regulations. • Do not discard the battery as domestic waste. • Send the battery to a Husqvarna service agent or discard it at a disposal location for used batteries. 1222 - 002 - 06.04.2020...

  • Page 23: Technical Data

    Technical data Technical data Honda, manual start Hatz, manual start Hatz, electrical start Net weight, kg/lb 500 mm: 263/580 500 mm: 280/617 500 mm: 300/661 600 mm: 268/591 600 mm: 285/628 600 mm: 305/666 Operation weight (EN500, incl. oil, ½ 500 mm: 265/584 500 mm: 282/621 500 mm: 302/672...
  • Page 24 Noise and vibration emissions, Honda Hatz Sound power level, measured dB (A) Sound power level, guaranteed L dB (A) Sound pressure level at the operator's ear, L , dB (A) Vibration level, a , m/s Noise and vibration declaration statement These declared values were obtained by laboratory type testing in accordance with the stated directive or standards and are suitable for comparison with the...
  • Page 25 Product dimensions Handle height, mm/in. Length including handle, 1120/44 1385/54.4 mm/in. Bottom plate contact area, 0.17/1.82 or Height, mm/in. Honda 735/28 /sq. ft. 0.21/2.25 Length bottom plate, Height, mm/in. Hatz 725/28.5 760/29.9 mm/in. Length with handle folded, Width, mm/in. 500/19.6 or 768/30.2 mm/in.

  • Page 26: Ec Declaration Of Conformity

    EC Declaration of Conformity EC Declaration of Conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Reversible Plate Compaction Machine Brand Husqvarna Type/Model LG 300 Identification Serial numbers dating from 2019 and onwards...
  • Page 27 1222 - 002 - 06.04.2020...
  • Page 28 www.husqvarnacp.com Original instructions 1140389-26 2020-04-06...