Advertisement
a) To turn the product with a minimum turning
radius, lift the handle to a 90 degrees angle. Use
this function in small spaces and on ground that
is not level.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the throttle control and choke control for damage.
Make sure that the throttle control and the choke control can move smoothly.
Examine the vibration damping units for damage.
Examine the tension of the V-belt and look for damages. Adjust or replace the V-belt
as necessary.
Engine maintenance
Do a check of the fuel level and the engine oil level.
2128 - 001 - 30.06.2023
Maintenance
Read and understand the
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
Before use,
After the
each 10 h
first 20 h
X
Before use,
Weekly,
each 10 h
each 100 h
*
X
*
*
*
X
X
Weekly,
Yearly, each
each 100 h
300 h
11
Advertisement
