Maintenance - Husqvarna BV 20 G Operator's Manual

8. When you start at the next section of the concrete
surface, put 15 cm/5.9 in. (A) of the beam on the
smooth concrete surface to make an overlap.
To adjust the operation angle of the
beam
1. Move the beam forward on the concrete surface. At
the same time turn the handle clockwise until the
front edge of the beam is slightly lifted.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance

Lubricate the swivel.
Clean the product.
Make sure that there are no fuel or
oil leaks.
Make sure that nuts and screws are
tightened.
10
2. Put the handle on your shoulder.
3. Pull the beam rearward. At the same time turn the
A
Maintenance
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
After the
Each use
first 10h
X
X
*
*
handle counterclockwise until the rear edge of the
beam is slightly lifted.
Each 25h Each 50h
Each 2
Yearly or
years or
each 100h
each 300h
1168 - 004 - 14.01.2022