Maintenance - Husqvarna SMART 40 Operator's Manual

Note: The vibrations start at a very low speed and
then increases slowly to maximum speed.
3. Push the ON/OFF switch to stop the product.
4. Disconnect the product from the power socket.
To operate the product
CAUTION: Do not use the product to move
the concrete to the side.
1. Fill concrete in equally thick layers, 30–50 cm / 12–
19 in. (B).
2. Put the vibrator head approximately 15 cm / 6 in. (A)
down into the nearest lower layer of concrete. This
causes the layers of concrete to mix correctly.
C
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
To clean the product
CAUTION: Do not use a high-pressure
washer to clean the product.
• Use running water from a hose to clean the product.
• Remove concrete from the surfaces of the product
after each operation before the concrete becomes
hard.
• Remove grease and oil from the handle.
To remove the vibrator head
1. Disconnect the product from the power outlet.
1004 - 001 - 01.04.2020
3. Wait approximately 10–20 seconds until the surface
around the vibrator head is shiny and no air bubbles
come to the surface.
4. Remove the vibrator head slowly to let the concrete
fill the hole from the vibrator head.
5. Put the vibrator head down into the concrete at a
distance of 30–50 cm / 12–19 in. (C) from where you
put it before.
6. Do step 4 and 5 again and again. Continue until the
air bubbles are fully removed from the area of
concrete.
B
A

Maintenance

2. Cut and discard the clamp that holds the wires on
the hose end that is adjacent to the frequency
converter.
3. Remove the cover from the frequency converter.
4. Cut the 3 connector wires and disconnect the ground
wire from the frequency converter.
5. Pull the hose from the end that is adjacent to the
frequency converter and remove the nut from the
casing.
6. Put the vibrator head in a tube vise and tighten the
tube vise fully.
7. Cut and discard the clamp that holds the wires on
the hose end that is adjacent to the vibrator head.
Pull the red hose until you can see the connectors.
8. Cut and discard the thermal insulation and
disconnect the terminals.
9. Disconnect the ground wire from the hose nipple.
7