Switching With The Cursor Buttons - Eaton easyE4 Manual

5.4.13 Switching with the cursor buttons

You can use the four cursor buttons on the easyE4 device as hardwired inputs in the
circuit diagram.
The P buttons can be used for testing circuits or for manual operation. The button
function is a useful addition for service and commissioning tasks.
Fig. 112: The cursor buttons are wired in the circuit diagram as contacts
Requirement:
The P buttons must have been enabled in the system menu.
Example 1
This standard circuit diagram example enables a lamp at output Q1 to either be
switched on or off via the inputs I1 and I2 or via the cursor buttons
Fig. 113: Switch Q1 via I1, I2,
Example 2
This circuit diagram example causes output Q1 to be actuated by input I1. I5 switches
to cursor operation and disconnects the rung
Fig. 114: I5 switches to cursor buttons.
The easyE4 device only evaluates P button entries if the
status display is shown.
The Status menu display shows whether the P buttons are used in the circuit dia-
gram.
easyE4 02/24 MN050009EN Eaton.com
5.4 Working with contacts and coils
, or
Í Ú
I
5. Programming on the device
to
P 01 P 04
.
ÍÚ
via .
01 M 01
.
205