Configuring Parameters In The Function Block Editor - Eaton easyE4 Manual

5. Programming on the device
5.6 Working with function blocks

5.6.3 Configuring parameters in the function block editor

220
Displays the
function blocks
used
Current cursor line
Fig. 119: Explanation of the function block list
Use the cursor buttons
function block list, in this case timing relay T01.
Confirm the selection by clicking the OK button.
The timing relay is displayed in the function block editor.
The function block can be fully parameterized in the function block editor.
This is accessed via the function block list.
Access is blocked if the program is password protected.
Function block num-
ber
Block name
Function block inputs
Function block out-
puts
Fig. 120: Manufacturer function block display in the function block editor
easyE4 02/24 MN050009EN Eaton.com
Function, special function,
parameter display
Free memory in bytes
to select the required function block from the
Function Unit/special function
Variable, operand for outputs
Parameter display (+ appears/ –
does not appear)
Basic parameters
Variable,
operand for inputs