Advertisement
Preparing the Table
Download and print the Cable Cubby F55 UT mounting template from the Extron website. Make sure that the template
dimensions are to scale. Position the template over the intended mounting surface location, secure with tape, and mark
the center of the holes where the mounting slots will be positioned. Alternatively, hold the Cable Cubby enclosure against
the intended mounting surface and mark where the holes will be positioned. Keep in mind that the enclosure will shift
approximately 3/16 inch (4.76 mm) forward or backward from the marked screw positions (see figure 5,
during the mounting process.
ATTENTION:
Make sure that the mounting template is printed to scale. Failure to do so may result in damaged
furniture and a failed installation.
NOTE: The diagram below is NOT to scale. Dimensions and templates are available online at www.extron.com.
Figure 4.
Cable Cubby F55 UT Mounting Template Sample (NOT TO SCALE)
Mounting Template for the Extron
Cable Cubby F55 UT
NOT TO SCALE. DO NOT USE AS MOUNTING TEMPLATE.
DOWNLOAD AND PRINT THE MOUNTING TEMPLATE
FROM THE EXTRON WEBSITE.
on
page
6)
3
5
Advertisement
