im Vertrieb von
HSA 400, 402, Installation, cont'd
Removing the HSA from the Table
Ensure that AC power is disconnected before
servicing the HSA unit.
1.
On the underside of the clamshell and in the enclosure, cut
the tie wraps that route the AAP cables out of the way.
2.
Disconnect the IEC power cord and the RJ-45 connectors
from the underside of the surface mount enclosure.
3.
Disconnect any cables connected to the existing AAPs at
the ends of the cables away from the HSA.
The edges of the top panel are sharp. Exercise care
when the HSA is removed from the table to prevent
personal injury.
CAUTION
The edges of the top panel are bevelled to an ultra-
fine thickness of less than 0.04 (4/100)"
(approximately 1 mm). These edges are soft and can
be easily nicked or bent. Exercise caution when
handling and mounting the enclosure.
Mishandling can damage the appearance of the
enclosure.
The surfaces of the HSA enclosure have screws and other
protrusions that could damage fine furniture. Do not
rest the enclosure on unprotected furniture.
4.
On the underside of the table, remove the two bolts that
secure the clamshell to the HSA (figure 1-3). Lift the
enclosure out of the table. Ensure that the cables
connected to the AAPs do not snag or pull on any
protrusions.
www.camboard.de
1-4
RJ-45 to RJ-11 Conversion Kit • HSA 400, 402 Installation
CAMBOARD Electronics
Tel. 07131 911201
RJ-45 to RJ-11 Conversion Kit • HSA 400, 402 Installation
Fax 07131 911203
IEC Power Cord
4 RJ-45 Connectors
Figure 1-3 — Removing the HSA 402 from the table
ce-info@camboard.de
HSA 402
Mounting
Surface
AAP Cables
Clamshell
Flat Washer
Full Thread
Mounting Bolts
1-5