Table of Contents
Advertisement
2.21.6 Lan Active LED(Pin 7 & Pin 8)
The LED would light when the Lan is active.
2.21.7 Lan Linked LED(Pin 9 & Pin10)
The LED would light when the Lan is linked.
2.22 Audio interface
2.22.1 Audio connector(CN8)
The Audio link is a 2x8 pin connector, the POD-6552can support
speaker-out, Line-IN, Line-out with Realtek ALC202, AC97 stereo
sound. Detailed pin assignment refer to Appendix A.
2.22.2 CD-In connector(CN16)
The POD-6552 can support CD-In via CN16.
2.23 Printer port connector (CN28)
Normally, the parallel port is used to connect the card to a printer. The
POD-6552 includes a multi-mode (ECP/EPP/SPP) parallel port accessed
via CN5 and a 26-pin flat-cable connector. You will need an adapter cable
if you use a traditional DB-25 connector. The adapter cable has a 26-pin
connector on one end, and a DB-25 connector on the other.
The parallel port is designated as LPT1, and can be disabled or changed to
LPT2 or LPT3 in the system BIOS setup.
The parallel port interrupt channel is designated to be IRQ7.
You can select ECP/EPP DMA channel via BIOS setup.
2.24 TV-out interface(CN3)
The POD-6552 board provides optional TV-out via CN3. This module
output supports S-video connectors. TV-out generators use both NTSC
and PAL formats with 640 x 480 or 800 x 600 MHz resolution.
To set up your video interface:
Run the appropriate installation program located on the utility disk.
That's all there is to it.
Download from Www.Somanuals.com. All Manuals Search And Download.
21
Chapter 2 Installation
Advertisement
Table of Contents
