Configuring The Pulse/Frequency; Switch Output - Endress+Hauser Proline Teqwave MW 300 Operating Instructions Manual

Proline Teqwave MW 300 HART
Parameter
Operating mode
Endress+Hauser
10.5.7 Configuring the pulse/frequency/switch output
The Pulse/frequency/switch output wizard guides you systematically through all the
parameters that can be set for configuring the selected output type.
Navigation
"Setup" menu → Advanced setup → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
Parameter overview with brief description
Prerequisite
If the Pulse option is selected,
the Load rate option must be
selected in the Assign pulse
output parameter.
Configuring the pulse output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
Terminal number
Signal mode
Assign pulse output
Pulse scaling
Pulse width
Failure mode
Description
Define the output as a pulse,
frequency or switch output.
Commissioning
→  89
Selection Factory setting
• Pulse Pulse
• Frequency
• Switch
→  90
→  90
→  90
→  90
→  90
→  90
→  90
89