Measured Variables Via Hart Protocol; Dynamic Variables - Endress+Hauser Proline Teqwave MW 300 Operating Instructions Manual

Proline Teqwave MW 300 HART
Parameter
Assign PV
Assign SV
Endress+Hauser
9.2

Measured variables via HART protocol

9.2.1

Dynamic variables

Measured variables can be assigned to the dynamic variables (PV, SV, TV and QV). This
assignment of variables can take place via local operation or via an operating tool.
The following parameters are available for the assignment of variables:
• Assign PV parameter (primary dynamic variable)
• Assign SV parameter (second dynamic variable)
• Assign TV parameter (third dynamic variable)
• Assign QV parameter (fourth dynamic variable)
Navigation
"Expert" menu → Communication → HART output → Output
Parameter overview with brief description
Prerequisite
The Load rate option is only
available if the volume flow of
the medium is read in via the
Current input 1 to n or the
fieldbus.
The Load rate option is only
available if the volume flow of
the medium is read in via the
Current input 1 to n or the
fieldbus.
Description
Assign measured variable to
primary dynamic variable (PV).
Assign measured variable to
the second dynamic variable
(SV).
System integration
Selection Factory setting
• Off Total solids
• Total solids
• Temperature
• Electronics
temperature
• Conductivity
• Corrected
conductivity
*
• Load rate
• Conductivity Temperature
• Corrected
conductivity
• Temperature
• Electronics
temperature
• Total solids
*
• Load rate
*
• Volume flow
*
• Totalizer 1
*
• Current input 1
*
• Current input 2
*
• Current input 3
• HART input
75