Advertisement
BRACKET LEVER AND SLIGHT
ADJUSTING LEVER
The Bracket levers and Slight adjusting levers
are set at both ends of the KR needle bed.
These two levers are used for letting down
the ribber.
1. When you knit the thicker yarn (more
than 5 ply), set the Slight adjusting levers
to the Bracket levers.
the Bracket levers so as to get the
thicker yarn knitting position.
will come down a little.)
2. Press down the Slight adjusting levers to
separate two levers (Fig. 27). And push
down the Bracket levers (Fig. 28), the
ribber will come down one step. This
pos1t1on (middle) 1s used for picking up
dropped stitches.
3. Push down the Bracket levers again and
the ribber will come down one more step.
At this position (lowest) the ribber is at
rest and single bed knitting can be done
without removing the ribber.
To return to working pos1t1on, push up the
ribber with both hands as high as 1t will go
until 1t stays still without holding
BRACKET SPACER
In case of knitting the thicker yarn (more
than 5 ply) with combination of KH-830
KR-830, use the Bracket spacers to keep the
clearance between each needle bed.
Raise the Bracket spacer on the Bracket,
and insert the Bracket into the knitter.
(See photograph 29)
Place the Bracket spacer between the
Bracket stopper plate and front edge of the
needle bed
Then fasten the thumb screw.
You do not have to use the Bracket spacer
for the combination of KH-820 KR-830.
Then push down
(The ribber
27 -;.......::::::.::;;... ___________ __ __,
1 1
Advertisement
