Quick Setup (Qset); Circuit Condition Display (Lmon) - Panasonic KX-TVS300 Installation Manual

SYSTEM MAINTENANCE AND TROUBLESHOOTING

7.2.17 Quick Setup (QSET)

Use the QSET command initially to setup the VPS very roughly when you use it for the first
time or after system initialization.
Note
Quick setup requires VT100 emulation software.
Type QSET, then Press RETURN.

7.2.18 Circuit Condition Display (LMON)

Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,
enter [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call"
"Outgoing Call"
"DSP Reset"
"PT connect"
"Error"
$ LMON
No.:
1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
Note
The maximum number of ports depends on the VPS model.
188
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PT connect disposition
: DSP Card is not loaded
Status Status
No.:
Ready 13: Error
Ready 14: Error
Ready 15: Error
Ready 16: Error
Ready 17: Error
Ready 18: Error
Ready 19: Error
Ready 20: Error
Ready 21: Error
Ready 22: Error
Ready 23: Error
Ready 24: Error
Installation Manual