Table of Contents
Advertisement
INTEGRATING THE VPS WITH THE PANASONIC KX-T DIGITAL PBX
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "CARD TEST" is displayed on the screen.
• "SYSTEM SETUP" is displayed.
Screen output:
CARD TEST...
SYSTEM SETUP...
1...
11... 12... 13... 14... 15... 16... 17...
• The VPS tests the CPU board, the hard disk drive, and
the CO cards as "SYSTEM SETUP..." is displayed.
• Active ports are displayed on the screen (the number of active ports depends on the
VPS model).
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
DPT Interface Connection is Established
Modem Card Initialization Completed
** ON LINE MODE **
Note:
You will see "Modem Card Initialization Completed" only when connecting the KX-
TVS300.
The display will alert you if System Setup is not completed successfully.
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
DPT Interface Connection is not Established
Modem Card Initialization Completed
** OFF LINE MODE **
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
Possible causes of the message: "DPT Interface Connection is not Established"
The PBX is not a KX-TD series or KX-TA1232
system. Since the VPS is configured to
communicate with the default PBX type at the
factory (KX-TD500 for the KX-TVS300; KX-
TD1232 for the KX-TVS110 and KX-TVS200),
this message will always appear when
connecting to another type of PBX.
106
2...
3...
4...
5...
6...
13 14 15 16 17 18 19 20 21 22 23 24
13 14 15 16 17 18 19 20 21 22 23 24
Table 20
Cause
7...
8... 9... 10...
Remedy
Connect a KX-TD series or
KX-TA1232 PBX and set the
PBX type by using Quick Setup
(see Section 5CUSTOMIZING
THE SYSTEM).
Installation Manual
Advertisement
Table of Contents
Troubleshooting
