Table of Contents
Advertisement
System Manual
6.7
Communication Connection
6.7.1 Overview
There is an RS485 communication terminal block inside the power distribution cabinet.
table 6-2 Port Mark and Definition (Example)
Marks
Reserved RS485
6.7.2 Procedure
Take one cable as an example.
Step 1 Use a wire stripper to strip off the RS485 shielded twisted pair.
Step 2 Press the metal plate above the terminal with a screwdriver.
Step 3 Insert the cable into the corresponding wiring hole.
Step 4 Loosen the screwdriver, the metal plate returns and compresses the cable.
* The figure is for reference only. The product received may differ.
- - End
6.8
Switch/Ethernet Communication
Overview
The switch or Ethernet port is set inside the power distribution cabinet, marked respectively
as A and B in the figure below. Please adopt switch or Ethernet communication according to
the actual situation on site.
Plug-compatible Devices
PVS, meteo station, electricity meter, transformer, etc.
6 Electrical Connection
47
Advertisement
Table of Contents
