Saeco AREA OTC SUPO48B Operation And Maintenance Manual page 48

English
8.4.4 Password setting
The PASSWORD must be set by the service provider
in order to prevent access by unauthorised personnel
who could change the machine settings and cause
malfunctions.
Three passwords can be set to access the three
different machine menus.
To set the PASSWORD, proceed as follows:
Switch to machine programming mode as described in
section "Access to the Technical Menu".
Press the "Down" button until the following menu is
displayed:
Press the "OK" button to enter the submenu of the
selected option. The following screen is displayed:
Press the "Down" or "Up" button to select the menu
for which to set the password. Press the "OK" button
to confirm. The following screen is displayed:
48
Press the "Down" or "Up" button to select the "Set"
option. Press the "OK" button to confirm and access
password programming. The following screen is
displayed:
To enter the password:
Press the "Up" or "Down" button to set the desired
number. Press the "OK" button to move to the next
number.
Repeat the steps until the set password has been
entered. Entered the last number the screen below
appears:
Press the "Up" or "Down" button to select the "Yes"
option and confirm the password.
In case you want to change an already set password
follow the same procedure. The following screen will
be displayed:
Select "Disable" to cancel the previously set password,
or select "Change" to modify the previously set
password.