Maintenance And Care - Flex LE 12-3 100 WET Original Operating Instructions

Setting
1
2
3
4
5
6
Remove the bail handle
Remove the bail handle if required.
Undo screws (1.) and remove the bail

handle (2.).
Attach the handle cover with plastic

screws (3.).
The power tool can now be used without the
bail handle.
Operating instructions
NOTE
When it is switched off, the polishing tool
continues running briefly.
When using the power tool, wear rubber

gloves.
Attach sanding tool.

Connect machine to the power supply.

Connect the water.

If required, adjust speed to the task

(LE 12-3 100 WET only).
Switch on the machine.

22
Speed (r.p.m.)
1200
1700
2200
2700
3200
3700
LE 12-3 100 WET/L 12-3 100 WET
Open shut-off valve on the water

connection.
Applying light pressure, place the grinding

tool on the material to be processed.
Excessive pressure will increase the wear
on the grinding tool and impair the grinding
result.
The polisher can be used for horizontal

and vertical work.
Hold the power tool in such a way that

water cannot run into the ventilation
slots.

Maintenance and care

WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and ventilation
slots. Frequency of cleaning is dependent
on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The electric power tool features cut-off
carbon brushes. When the cut-off carbon
brushes reach their wear limit, the electric
power tool switches off automatically.
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.