Table of Contents
Advertisement
Switching on and off
Switch power tool on or off by pressing on/off
switch (see figure H).
CAUTION!
Following a power failure, the switched-on
power tool will not start running again.
Operating instructions
WARNING!
Hold the electric power tool by the insulated
grip surfaces only!
CAUTION!
When the power tool is switched off, the
grinding tool continues running briefly.
Switch on the sander and place the whole
sanding sheet on the surface to be processed.
Applying moderate pressure, move the
sander evenly over the workpiece.
The sanding result is determined primarily
by the selection of the correct sanding
sheet, the selected number of oscillations
and the contact pressure.
Replace sanding sheets in good time.
An excessive increase in the contact
pressure will not increase the grinding
performance, but will increase the
wear on the electric power tool and the
sanding tool.
For further information on the manufacturer's
products go to www.flex-tools.com.
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior and
motor with dry compressed air.
Spare parts and accessories
For other accessories, in particular tools
and sander accessories, can be found in the
manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
14
ORE 2-125 EC / OSE 2-80 EC / ODE 2-100 EC
Disposal information
WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
EU countries only
Do not throw electric power tools into
the household waste! In accordance
with the European
Directive 2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
NOTE
Please ask your dealer about disposal
options!
-Declaration of Conformity
We declare under our sole responsibility
that the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 62841 in accordance with the regulations
of the directives 2014/30/EU, 2006/42/EC,
2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
01.03.2021; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Klaus Peter Weinper
Head of Quality
Department (QD)
Advertisement
Table of Contents
